Garmin G5 Electronic Flight Instrument Part 23 AML STC Maintenance Manual 190-01112-11
Rev. 7
Page 23 of 54
6 EQUIPMENT REMOVAL & INSTALLATION
This section describes how to remove and install the equipment associated with this STC.
The G5 System equipment part numbers approved by STC SA01818WI-A are found in Table 1-2 of
Garmin document 190-01112-10, Garmin G5 Part 23 AML STC Installation Manual.
6.1 G5 Unit
CAUTION:
When removing and/or installing the G5, always ensure that aircraft power is off. Unplug any
auxiliary power supplies.
Removal
Removal and reinstallation procedure for a standard G5 installation or a G5 recessed into the panel is
identical.
1. Insert a hex drive tool through the access hole in the front cover of the G5 as shown in Figure 6-1
loosen the unit from the mounting ring.
Figure 6-1 G5 Hex Driver
2. Disconnect the pitot and static lines from the G5 unit.
3. Disconnect the electrical connector and GPS coaxial cable connector (if installed) from the G5
unit.
4. Remove the G5 unit.
To Next Page
Loading...
Need help?
General
