Garmin G5 Maintenance Manual

Garmin G5 Electronic Flight Instrument Part 23 AML STC Maintenance Manual 190-01112-11
Rev. 7
Page 33 of 54
4" MAX
1.5(±0.2)"
2.1(±0.2)"
2.7(±0.2)"
STEPS FOR COMPONENT INSTALLATION:
1. CREATE COMPONENT BUILDUPS AS SHOWN IN FIGURE 6-7.
2. SOLDER RESISTOR BUILDUPS TOGETHER AS SHOWN IN THE ABOVE FIGURE PER AS4461. A SIMPLIFIED CIRCUIT IS SHOWN BELOW.
NOTE: ACCEPTABLE SOLDER TYPES ARE SN60 OR SN63. CLEAN FLUX RESIDUES USING AN APPROPRIATE FLUX CLEANER.
3. SECURE THE COMPONENTS TOGETHER IN THE WIRE BUNDLE AS SHOWN ABOVE.
NOTE: THE "-Y" CHARACTER IN THE CABLE TIE P/N IS FOR COLOR, COLOR OF CABLE TIE IS THE INSTALLERS CHOICE.
15 OHM
15 OHM
120 OHM
CAN-H
CAN-L
()P51
1
2
AIRCRAFT WIRING
15 OHM RESISTOR (STEP 1)
15 OHM RESISTOR (STEP 1)
120 OHM RESISTOR (STEP 1)
STEP 2
CABLE TIE
(STEP 3, P/N MS3367-4-Y)
CABLE TIE
(STEP 3, P/N MS3367-4-Y)
CABLE TIE
(STEP 3, P/N MS3367-4-Y)
78 PIN CONNECTOR IS
SHOWN AS REFERENCE ONLY
FOR REMAINING SHIELD TERMINATION AND
CONNECTOR ASSEMBLY INSTRUCTIONS REFER TO 190-01112-10, G5 STC IM, SECTION 4.2
STEP 2
Figure 6-9 Method B Placement of CAN Bus Components (G5 as CAN bus terminator)

Garmin G5 Specifications

General

Brand	Garmin
Model	G5
Category	Avionics Display
Language	English