Garmin OREGON OREGON450 User Manual

Oregon Series Owner’s Manual 25
Customizing the Oregon
To add a new prole:
Touch Setup > Proles >
<Create New Prole>. This
prole is a copy of your current
prole. The new prole becomes
your current prole.
Using System Setup
Touch Setup > System.
GPS—select Normal, WAAS
(Wide Area Augmentation System),
or Demo Mode (GPS off). For
information about WAAS, go to
www.garmin.com/aboutGPS
/waas.html.
Language—select the text language
on the Oregon. Changing the text
language does not change the
language of user-entered data or map
data, such as street names.
Battery Type—select the type of
battery you are using.
Tones—turn audible tones On or
Off.
Interface—set the Oregon serial
interface:
Garmin Spanner—allows you
to use the Oregon USB port with
most NMEA 0183-compliant
mapping programs by creating a
virtual serial port.
Garmin Serial—Garmin
proprietary format used to
provide PVT protocol data.
NMEA In/Out—provides
standard NMEA 0183 output and
input.
Text Out—provides simple
ASCII text output of location and
velocity information.
RTCM —receive differential
corrections from a RTCM
beacon.
•
•
•
•
•

Garmin OREGON OREGON450 Specifications

General

Display Resolution	240 x 400 pixels
Battery Type	2 AA batteries (not included); NiMH or Lithium recommended
Battery Life	Up to 16 hours
Water Rating	IPX7
High-Sensitivity Receiver	Yes
Interface	USB
Built-in Memory	850 MB
Expandable Memory	microSD card (not included)
Waypoints/Favorites/Locations	1000
Routes	50
Track Log	10, 000 points, 200 saved tracks
Geocaching-Friendly	Yes (Paperless)
Custom Maps Compatible	Yes
Photo Navigation	Yes
Area Calculation	Yes
Picture Viewer	Yes
Preloaded Maps	No
Compass	Yes (tilt-compensated 3-axis)
Barometric Altimeter	Yes
Physical Dimensions	5.8 x 11.4 x 3.5 cm
Wireless Communication	ANT+
Compatibility	Garmin Connect
Display Size	3.0 inches