Garmin OREGON OREGON450 User Manual

32 Oregon Series Owner’s Manual
Customizing the Oregon
at a higher rate of speed for a set
period of time. Select Off to turn the
electronic compass off and use the
GPS compass.
Calibrate—calibrate the compass
(page 10).
Altimeter Setup
Touch Setup > Altimeter.
Auto Calibration—allow the
altimeter to self-calibrate each time
you turn the Oregon on.
Barometer Mode—select Variable
Elevation (used when moving)
or Fixed Elevation (used when
stationary, allowing the altimeter to
function as a standard barometer).
Pressure Trending—select when
the pressure data is recorded. Touch
Save Always to record pressure data
every 15 minutes, even when the
Oregon is turned off. Touch Save
When Power On to record data only
when the Oregon is turned on. This
can be useful when you are watching
for pressure fronts.
Plot Type—select the elevation plot
type:
Elevation/Time—records
elevation changes over a period
of time.
Elevation/Distance—records
elevation changes over a
distance.
Barometric Pressure—records
barometric pressure over a period
of time.
Ambient Pressure—records
ambient pressure changes over a
period of time.
•
•
•
•

Garmin OREGON OREGON450 Specifications

General

Display Resolution	240 x 400 pixels
Battery Type	2 AA batteries (not included); NiMH or Lithium recommended
Battery Life	Up to 16 hours
Water Rating	IPX7
High-Sensitivity Receiver	Yes
Interface	USB
Built-in Memory	850 MB
Expandable Memory	microSD card (not included)
Waypoints/Favorites/Locations	1000
Routes	50
Track Log	10, 000 points, 200 saved tracks
Geocaching-Friendly	Yes (Paperless)
Custom Maps Compatible	Yes
Photo Navigation	Yes
Area Calculation	Yes
Picture Viewer	Yes
Preloaded Maps	No
Compass	Yes (tilt-compensated 3-axis)
Barometric Altimeter	Yes
Physical Dimensions	5.8 x 11.4 x 3.5 cm
Wireless Communication	ANT+
Compatibility	Garmin Connect
Display Size	3.0 inches