Garmin OREGON OREGON450 User Manual

Oregon Series Owner’s Manual 41
Appendix
Attaching the Carabiner
1. Position the carabiner clip in the
slots on the mounting spine of the
Oregon.
Carabiner clip
Carabiner
Mounting spine
2. Slide the clip up until it locks in
place.
To remove the carabiner clip, lift
the bottom of the clip and slide the
carabiner clip off the mounting spine.
Calibrating the
Touchscreen
The Oregon screen does not
normally require calibration.
However, if the buttons do not seem
to be responding properly, use the
following process.
To calibrate the touchscreen:
1. While the unit is turned off, press
and hold the Power key for
approximately 30 seconds.
2. Follow the instructions on the
screen until “Calibration is
complete” appears.

Garmin OREGON OREGON450 Specifications

General

Display Resolution	240 x 400 pixels
Battery Type	2 AA batteries (not included); NiMH or Lithium recommended
Battery Life	Up to 16 hours
Water Rating	IPX7
High-Sensitivity Receiver	Yes
Interface	USB
Built-in Memory	850 MB
Expandable Memory	microSD card (not included)
Waypoints/Favorites/Locations	1000
Routes	50
Track Log	10, 000 points, 200 saved tracks
Geocaching-Friendly	Yes (Paperless)
Custom Maps Compatible	Yes
Photo Navigation	Yes
Area Calculation	Yes
Picture Viewer	Yes
Preloaded Maps	No
Compass	Yes (tilt-compensated 3-axis)
Barometric Altimeter	Yes
Physical Dimensions	5.8 x 11.4 x 3.5 cm
Wireless Communication	ANT+
Compatibility	Garmin Connect
Display Size	3.0 inches