Garmin OREGON OREGON450 User Manual

2 Oregon Series Owner’s Manual
Getting Started
Battery Information
The Oregon uses two AA batteries.
Use alkaline, NiMH, or lithium
batteries. Use precharged NiMH or
lithium batteries for the best results.
Standard alkaline batteries are not
recommended for Oregon 550 units
when using the camera feature.
To install the batteries:
1. Lift the latch, and remove the
battery cover.
Latch
Battery cover
Weather cap
2. Insert the batteries, observing
polarity.
3. Replace the battery cover, and
push the latch down.
To select the battery type:
1. Touch Setup > System > Battery
Type.
2. Touch
Alkaline, Lithium, or
Rechargeable NiMH.
Long-Term Storage
Remove the batteries when you do
not plan to use the Oregon for several
months. Stored data is not lost when
batteries are removed.
Turning the Oregon On
and Off
1. To turn on the Oregon, press .
2. To turn off the Oregon, press and
hold .

Garmin OREGON OREGON450 Specifications

General

Display Resolution	240 x 400 pixels
Battery Type	2 AA batteries (not included); NiMH or Lithium recommended
Battery Life	Up to 16 hours
Water Rating	IPX7
High-Sensitivity Receiver	Yes
Interface	USB
Built-in Memory	850 MB
Expandable Memory	microSD card (not included)
Waypoints/Favorites/Locations	1000
Routes	50
Track Log	10, 000 points, 200 saved tracks
Geocaching-Friendly	Yes (Paperless)
Custom Maps Compatible	Yes
Photo Navigation	Yes
Area Calculation	Yes
Picture Viewer	Yes
Preloaded Maps	No
Compass	Yes (tilt-compensated 3-axis)
Barometric Altimeter	Yes
Physical Dimensions	5.8 x 11.4 x 3.5 cm
Wireless Communication	ANT+
Compatibility	Garmin Connect
Display Size	3.0 inches