Installation: Connections
3-6 Dash 3000/4000/5000 2000966-542D
The TRAM-rac 2A module housing does not have an Analog Output
connector.
BISx module
The BISx module connects to the patient monitor via a RJ-45 cable that
plugs into the Aux port on the patient monitor and a Y-cable. One end of
the Y-cable plugs into a power supply and the other end plugs into the
BISx module cable.
Remote control
The remote control connects to the patient monitor via a communications
cable which plugs into an Autoport to M-port adapter before it is inserted
into the Aux port on the Dash patient monitor or the Dash Port 2
docking station.
The remote control is programmed for specific care areas (adult,
neonatal, or operating room).
NOTE
The error message WARNING: REMOTE MISMATCHED WITH
MONITORING MODE displays if a mismatched remote control is
connected to the patient monitor.
AC power
Auto Port to the patient
monitor’s Aux Port
Async Comm
power switch
006A
822A
remote control
Aux port adapter
To Next Page
Loading...
Need help?
General