Configuration: Service Mode settings
2000966-542D Dash 3000/4000/5000 4-15
Type in the PASS KEY exactly, using no extra spaces. PASS
KEY entries must be at least 8 characters for TKIP or AES-
CCMP. The message TKIP KEY MUST BE AT LEAST 8
CHARACTERS displays.
The SSID (1/2) setting is limited to 20 ASCII characters of case-
sensitive upper/lower case letters and ASCII decimal numbers.
The SSID (2/2) setting is limited to 12 ASCII characters of case-
sensitive upper/lower case letters and ASCII decimal numbers.
The PASS KEY entries are limited to 13 ASCII characters, 20
hex characters for WEP, and 8-63 ASCII characters or 64 hex
characters for TKIP or AES-CCMP.
The SSID and PASS KEY entries are case sensitive.
NOTE
When using the 802.11 a/b/g wireless option, the PRIORITY
configuration setting is not used. If you attempt to change this
setting, the WLAN PRIORITY SETTING IS NOT SUPPORTED
FOR THIS CARD message displays.
7. Select MORE WLAN SETTINGS from the MONITOR SETTINGS
menu.
NOTE
The MORE WLAN SETTINGS menu option only supports the
802.11 a/b/g wireless card.
8. Select FREQ. BAND and set to ALL BANDS.
9. Select RTS THRESHOLD and set to 2347, unless otherwise
specified in the wireless network design.
10. Select FRAG. THRESHOLD and set to 2346, unless otherwise
specified in the wireless network design.
11. Select ANTENNA and set to ENABLED.
To Next Page
Loading...
Need help?
General