GE
Direction 5370626-100, Revision 18 LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e Basic Service Manual
4-20 Section 4-3 - General Procedure
4-3-10 Doppler Mode Checks
4-3-10-1 Preparations
1.) Connect one of the probes listed in 3-6-6 "Available Probes" on page 3-28, in Chapter 3 Installation
to the System probe connector.
2.) Turn ON the scanner (if it isn’t turned on already).
Figure 4-13 Controls available in Doppler Mode
Figure 4-14 Doppler Mode Screen Picture Example
Primary Menu
Secondary Menu
M/D Cursor
PW Mode
Gain
B Pause/Enter
To Next Page
Loading...
Need help?
General
