GE LOGIQ e R6 Series User Manual

GE
Direction 5370626-100, Revision 18 LOGIQ e/LOGIQ e Vet/LOGIQ i/Vivid e Basic Service Manual
Chapter 7 Diagnostics/Troubleshooting 7-25
7-7-3 Insite II Configuration (For LOGIQ e R6.x.x/R7.x.x and LOGIQ e Vet R6.x.x/
R7.x.x) (cont’d)
3.) Set Disruptive Mode Status as Enabled. Change to Utilities
page. select Disruptive Mode in the left
column, Check whether the Disruptive Mode Status is Enabled, if not, click Yes
to change the
Disruptive Mode Status as Enabled. See Figure 7-28 on page 7-25 .
There is another way to Set Disruptive Mode Status as Enabled. Click Insite Icon in system status bar,
choose Connect clinical Lifeline, the Insite Icon will change to RED, do not need to change if the Insite
icon is already RED. See Figure 7-29 on page 7-25 .
Figure 7-28 Device_Information page
Figure 7-29 Set Disruptive Mode Status

GE LOGIQ e R6 Series Specifications

General

Brand	GE
Model	LOGIQ e R6 Series
Category	Medical Equipment
Language	English