17–14 MULTILINK ML2400 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
MISCELLANEOUS COMMANDS CHAPTER 17: MISCELLANEOUS COMMANDS
17.7 Prompt
17.7.1 Changing the Command Line Prompt
Setting a meaningful host prompt can be useful when a network administrator is
managing multiple switches and has multiple telnet or console sessions. To facilitate this,
the ML2400 allows administrators to define custom prompts. The command to set a
prompt is:
set prompt <prompt string>
The length of the prompt is limited to 60 characters.
There are predefined variables that can be used to set the prompt. These are:
• $n: system name
• $c: system contact
• $l: system location
• $i: system IP address
• $m: system MAC address
•$v: version
• $$: the “$” (dollar sign) character
• $r: new line
•$b: space
A few examples on how the system prompt can be setup are shown below.
ML2400# snmp
ML2400(snmp)## setvar sysname=Core
System variable(s) set successfully
ML2400(snmp)## exit
ML2400# set prompt $n
Core# set prompt $n$b$i
Core 192.168.5.5# set prompt $n$b$i$b
Core 192.168.5.5 # snmp
Core 192.168.5.5 (snmp)## setvar sysname=ML2400
System variable(s) set successfully
Core 192.168.5.5 (snmp)## exit
Core 192.168.5.5 # set prompt $b$b$i$b
192.168.5.5 # set prompt $n$b$i$b
ML2400 192.168.5.5 #
ML2400 192.168.5.5 # set prompt Some$bthing$i
Some thing192.168.5.5# set prompt Some$bthing$b$i
Some thing 192.168.5.5#
To Next Page
Loading...
Need help?
General
