14 NX-
LOCATION 8 CODES 1-10 OUTPUT ENABLE
(10 segments of feature selection data)
When activating outputs with a user code (event #30), location 8 can be used to restrict certain codes from
activating certain outputs. Location 8 contains 10 segments. Segment 1 corresponds to user 1; Segment 10
corresponds to user 10. The LEDs correspond to outputs A - C.
Table XII:2
LED
DESCRIPTION
1
"On" if code will activate Output A; "Off" if it will not.
2
"On" if code will activate Output B; "Off" if it will not.
3
"On" if code will activate Output C; "Off" if it will not.
4
Reserved.
LOCATION 9 CODES 11-20 OUTPUT ENABLE
(10 segments of feature selection data)
When activating outputs with a user code (event #30), location 9 can be used to restrict certain codes from
activating certain outputs. Location 9 contains 10 segments. Segment 1 corresponds to user 11; Segment 10
corresponds to user 20. The LEDs correspond to outputs A - C (see Table XII:2).
LOCATION 10 CODES 21-30 OUTPUT ENABLE
(10 segments of feature selection data)
When activating outputs with a user code (event #30), location 10 can be used to restrict certain codes from
activating certain outputs. Location 10 contains 10 segments. Segment 1 corresponds to user 21; Segment 10
corresponds to user 30. The LEDs correspond to outputs A - C (see Table XII:2 on page 14).
LOCATION 11 CODES 31-40 OUTPUT ENABLE
(10 segments of feature selection data)
When activating outputs with a user code (event #30), location 11 can be used to restrict certain codes from
activating certain outputs. Location 11 contains 10 segments. Segment 1 corresponds to user 31; Segment 10
corresponds to user 40. The LEDs correspond to outputs A - C (see Table XII:2 on page 14).
LOCATION 12 CODES 41-50 OUTPUT ENABLE
(10 segments of feature selection data)
When activating outputs with a user code (event #30), location 12 can be used to restrict certain codes from
activating certain outputs. Location 12 contains 10 segments. Segment 1 corresponds to user 41; Segment 10
corresponds to user 50. The LEDs correspond to outputs A - C (see Table XII:2 on page 14).
LOCATION 13 CODES 51-60 OUTPUT ENABLE
(10 segments of feature selection data)
When activating outputs with a user code (event #30), location 13 can be used to restrict certain codes from
activating certain outputs. Location 13 contains 10 segments. Segment 1 corresponds to user 51; Segment 10
corresponds to user 60. The LEDs correspond to outputs A - C (see Table XII:2 on page 14).
To Next Page
Loading...
Need help?
General
