Vscan Air Battery
Vscan Air – User Manual 3-17
Direction GP092020-1EN Rev 18
Vscan Air Battery
Battery
The Vscan Air CL probe is powered by a Li ION battery. The
battery is not fully charged prior to shipment. To maximize time
of use, it is recommended to recharge the battery before use for
at least 1.5 hours. Establish a routine for charging the battery to
maximize device availability.
The battery will be charged when charging the Vscan Air CL
probe as described in the section ‘How to charge the Vscan Air
CL’ on page 3-4
The battery specification is shown in the below table.
Battery specification
Table 3-3: Battery specification
Items Unit Value Description
Basic Voltage mV 3600 MAX
Current mA 889 Avg 0.71C
Use only AC adapter that are compliant to (marked with)
applicable regional or country standards.
The Vscan Air CL probe is not certified for being charged inside
a road- or air ambulance.
The AC adapter and the wireless charger pad must be kept
outside the patient environment (refer to local regulation and
EN 60601-1). The user should perform charging of the Vscan
Air CL outside the patient area.
To Next Page
Loading...
Need help?
General
