Programming a new wash program 39
Code 429159
Rev. 15/0717
7.3.4. Heating gradient
Optional programming
The increase in bath temperature can be controlled in different gradients defined in degrees/minute.
The type and power of heating, the load in the washing machine and the water temperature can modify the
heating speed, mainly in the fastest gradients.
Requirements that allow the programming of this function:
Machine with heating system installed and duly activated in the SETUP menu.
Programming option activated in the corresponding stage of the CONFIGURATION menu.
Temperature programmed in that phase.
Heating gradients
Value in Centigrade degrees: 1º / minute
Value in Fahrenheit degrees: 2.0º / minute
Value in Centigrade degrees: 2º / minute
Value in Fahrenheit degrees: 3.5º / minute
Value in Centigrade degrees: 3º / minute
Value in Fahrenheit degrees: 5.5º / minute
Gradient reachable only with steam heating
Constant heating connection
<<< Option programmed by default
7.3.5. Product dosing
It is possible to programme the dosing of up to four products simultaneously in each phase.
Programming the second product will only be possible if the first dosing has been programmed, and so on
successively until the fourth product.
The programming of two concurrent internal doses will only be possible in the first and second dosing position.
The third and fourth position should be exclusively for external dosings or no dosing.
The option of dosing up to four products simultaneously is only available on models with microprocessor
Version 21D/21F or later.
Dosing icon of the first product
Dosing icon of the second product
Dosing icon of the third product
Dosing icon of the fourth product
To Next Page
Loading...
Need help?
General
