To Next Page

To Previous Page

Troubleshooting 73

Code 429159

Rev. 15/0717

14.5. What to do when…

Some of the washing machine’s operating problems can be solved through the intervention of the user.

These problems are detailed below.

Should you have any questions, remember to consult the Authorised Technical Service.

..... the wash cycle ends with the report: PERSISTENT UNBALANCE.

This report indicates that the final spin cycle is not possible because the load is unbalanced.

 Unload the machine and load it again.

 Begin the wash cycle and accelerate the program to the last phase.

 The washing machine will repeat the last spin cycle without refilling with water.

 If the problem persists, or occurs often, contact the Authorised Technical Service.

..... ….the machine makes a strange noise during the spin cycle.

 Check the levelling of the machine. See Instruction Manual for Installation.

 Tighten the locking screws on the outside panels.

 If the problem persists, contact the Authorised Technical Service.

..... the door may have a leak.

 Clean the door seal of any possible deposits or remains of cloth.

..... there is water leaks inside the washer cabinet.

 Check the outlet draining pipe.

 Check the seals on the water inlet hoses; tighten the connection couplings.

 Check the condition of the door seal and if there are any ruptures.

 If the problem persists, seal all of the water inlets and contact the Authorised Technical Service.

..... you have forgotten the access code for the advanced operating mode.

 Call the Authorised Technical Service.

..... the clock stops working correctly

 Possible battery failure. Contact the Authorised Technical Service to have it replaced.

GIRBAU EH060 User Manual

Other manuals for GIRBAU EH060