GIRBAU EH060 User Manual

Cleaning of recovery tank menu 70
Code 429159
Rev. 15/0717
13. CLEANING OF RECOVERY TANK MENU
(available only in models with AS recovery tank)
Introduction and access
This menu allows programming and starting a filling and draining sequence of the tank recovery to better get rid
of the rests inside the recovery tank.
Options:
 Number of washes. To program the number of washes to be executed during each cleaning operation. A
wash is meant to be a water filling and emptying cycle. At each wash the washer fills water up to a preset
level. Once this level is reached, the water is pumped from inside the washer to the recovery tank. The
pump operation is intermittent to create a higher turbulence inside the tank.
Once the washes set time is over, the pump operation is interrupted and the main drain is opened and the
bath from the inside of the washer is drained.
 Wash time. To program each wash time (time in minutes)
 Water inlet to be used: cold and hot
 Washing start. Start order for the cleaning sequence
13.1. Configuration of parameters and wash start
Follow the keyboard use instructions in section 10.1.
The number values programming can be done either through the multi-function keyboard or the alphanumeric
keyboard.
NUMBER OF WASHING
Programming the number of washings to carry out during each cleaning
Programmable values ..............
1 a 5 washings
Factory settings .........................
1
WASHING TIME
Programming of each wash time
Programmable values ............
1 to 5 minutes
Factory settings .......................
1
WATER INLET
Definition of type of water to be used for the tank cleaning
Programmable values ..............
cold water / hot water
Factory settings .........................
cold water
WASH START
Start wash process command
Action ........................................
Close the door.
Press OK key from the function keyboard.

GIRBAU EH060 Specifications

General

Brand	GIRBAU
Model	EH060
Category	Washer
Language	English