GIRBAU EH060 User Manual

System tools 61
Code 429159
Rev. 15/0717
CLEANING DISPENSERS
Option that opens the water inlet valves of the four dispenser compartments, before the final drain of the
program, during the time specified in this section.
Its objective is to get rid of product remains that could have been deposited inside.
The multi-function and numerical keyboard can be used interchangeably.
This option can increase the water consumption of the washing machine.
Programmable values ..............
0...30 seconds
Factory settings .........................
0 seconds (NO dispensers cleaning)
CLEANING THE DISTRIBUTOR
Option that opens a cold water inlet valve once the external product dosing has finished.
Its objective is to get rid of product remains that could have been deposited inside the distributor.
This option can increase the water consumption of the washing machine.
Programmable values ..............
YES / NO
Factory settings .........................
YES
MINIMUM BATH TEMPERATURE
Configuration only permitted in machines supplied with hot and cold water. Value A2 = C in SETUP.
Option destined to maintain a minimum cold water temperature of 18ºC/64F in all the programs.
In the YES configuration, whenever the temperature programmed is less than 18ºC/64F, the washing
machine mixes hot and cold water until reaching this temperature. The temperature is increased by mixing
water, never by connecting the heating system.
Programmable values ..............
YES / NO
Factory settings .........................
NO
THE EASY LOAD SYSTEM
An option that allows the user to activate the TILT + EASY LOAD system to aid loading and unloading as
described in Section 4.10.
This configuration is only possible in machines with the TILT SYSTEM installed.
Requires the BOARD A10 and TILT SYSTEM parameters to be activated in the SETUP menu.
Programmable values ............
YES / NO
Factory settings .......................
NO
PUMP SWITCH
Switching delay time of pump with valve normally open (N.O.) or normally closed (N.C.) after detecting that
there is no water level left during draining/spinning.
A configuration only associated with machines with draining variations: Pump + Drain N.O. or Pump + Drain
N.C.
It requires the draining variations to be activated in the SETUP menu.
Programmable values ..............
10/ 250 seconds
Factory settings .........................
60 seconds
NETWORK IDENTIFIER
This parameter assigns a network identifier to the washer. This identifier enables the communication of the
washer with the environment through a protocol based on RS-485.
Programmable values ...........
0 (disabled communication) / 1..99 (enabled communication)
Factory settings ......................
0
(For further information, see the Communication Protocol Instruction Manual)
10.2.2. Advanced programming options
PROGRAMMABLE DOSING TIME
Activates the programming described in section 7.3.6. that permits programming the duration at each dosing.

GIRBAU EH060 Specifications

General

Brand	GIRBAU
Model	EH060
Category	Washer
Language	English