System tools 63
Code 429159
Rev. 15/0717
10.2.3. Modifiable values tables
BATH LEVELS
Modifying the value of the six bath levels within the established limits is possible, always respecting the
ordering criteria from lowest to highest. The value of each level in millimetres must always be higher than
the lower level and smaller than higher level.
The programmed height of the bath is approximately equivalent to the height of the water visible through the
lower part of the drum, expressed in millimetres.
These values must be checked with the drum stopped (programming NO rotation in the phase).
Values programmable by the numerical keyboard.
Programming limits and table of factory settings depending on the machine model.
level values by default in mm
machines WITHOUT heating system
Example of programming levels>>>>>>>
(based on a washer HS-6017 / EH040 model)
Programmable L3 (level 3) range:
min: L2 + 1= 79mm.
max: L4 – 1= 139mm.
ATTENTION!
In certain machines with a heating system the L1 level and L2 level are increased.
level values by default in mm
machines WITH heating system
ATTENTION!
Increasing the bath levels increases the water and energy consumption of the washing machine.
The habitual usage of the bath level greater than the default value of level 6 considerably reduces the life of
the seals and bearings.
Do not increase the level values if it is not absolutely necessary.
To Next Page
Loading...
Need help?
General
