Component Identification
6 3A2989V
Keep Components A and B
Separate
Changing Materials
Components A and B
IMPORTANT!
Material suppliers can vary in how they refer to plural
component materials.
Be aware that in this manual:
Component A refers to resin or major volume.
Component B refers to the hardener or minor volume.
This equipment doses the B component into the A com
ponent flow. An integration hose must always be used
after the mix manifold and before the static mixer.
Component Identification
See sprayer Setup - Operation manual for component
identification.
Grounding
All components shipped from the factory are electrically
bonded through ground wires. Ground the electrical
connection properly according to local codes.
PERSONAL PROTECTIVE EQUIPMENT
Wear appropriate protective equipment when in the work area to help prevent serious injury, including
eye injury, hearing loss, inhalation of toxic fumes, and burns. Protective equipment includes but is not
limited to:
• Protective eyewear, and hearing protection.
• Respirators, protective clothing, and gloves as recommended by the fluid and solvent manufacturer.
SPLATTER HAZARD
Hot or toxic fluid can cause serious injury if splashed in the eyes or on skin. During blow off of platen,
splatter may occur.
• Use minimum air pressure when removing platen from drum.
WARNINGWARNINGWARNING
WARNING
Cross-contamination can result in cured material in
fluid lines which could cause serious injury or damage
equipment. To prevent cross-contamination:
• Never interchange component A and component
B wetted parts.
• Never use solvent on one side if it has been con
taminated from the other side.
NOTICE
Changing the material types used in your equipment
requires special attention to avoid equipment damage
and downtime.
• When changing materials, flush the equipment mul
tiple times to ensure it is thoroughly clean.
• Always clean any fluid inlet strainers after flushing.
• Check with your material manufacturer for chemical
compatibility.
• When changing between epoxies and urethanes or
polyureas, disassemble and clean all fluid compo
nents and change hoses. Epoxies often have
amines on the B (hardener) side. Polyureas often
have amines on the B (resin) side.
The equipment must be grounded to reduce the risk
of static sparking and electric shock. All internal earth
grounding must use only copper wires. See
Electrical Schematics,page 31, for wire size.
Electric or static sparking can cause fumes to ignite
or explode. Improper grounding can cause electric
shock. Grounding provides an escape wire for the
electric current.
To Next Page
Loading...
Need help?
General
