EasyManuals Logo
Home>Growatt>Inverter>MIN 7000TL-X

Growatt MIN 7000TL-X User Manual

Growatt MIN 7000TL-X
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
19
5.1 Safety instructions
Danger to life due to fire or explosion
Despite careful construction, electrical devices can cause fires.
Do not install the inverter on easily non-flammable materials
and where non-flammable materials are stored.
Risk of burns due to hot enclosure parts
Mount the inverter in such a way that it cannot be touched
inadvertently.
Possible damage to health as a result of the effects of radiation!
In special cases, there may still be interference for the specified
application area despite maintaining standardized emission limit
values (e.g. when sensitive equipment is located at the setup
location or when the setup location is near radio or television
receivers).In this case, the operator is obliged to take proper
action to rectify the situation.
Never install the inverter near the sensitive equipmente.g.
Radios, telephone, television, etc
Do not stay closer than 20 cm to the inverter for any length of
time unless it is absolutely necessary.
Growatt assumes no responsibility for compliance to EMC
regulations for the complete system
All electrical installations shall be done in accordance with the local and national
electrical codes. Do not remove the casing. Inverter contains no user serviceable
parts. Refer servicing to qualified service personnel. all wiring and electrical
installation should be conducted by a qualified service personnel .
Carefully remove the unit from its packaging and inspect for external damage. If
you find any imperfections, please contact your local dealer.
Be sure that the inverters connect to the ground in order to protect property and
personal safety.
The inverter must only be operated with PV generator. Do not connect any other
source of energy to it.
Both AC and DC voltage sources are terminated inside the PV Inverter. Please
disconnect these circuits before servicing.
This unit is designed to feed power to the public power grid (utility) only. Do not
connect this unit to an AC source or generator. Connecting Inverter to external

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Growatt MIN 7000TL-X and is the answer not in the manual?

Growatt MIN 7000TL-X Specifications

General IconGeneral
BrandGrowatt
ModelMIN 7000TL-X
CategoryInverter
LanguageEnglish

Related product manuals