Haier HLP24E Service Manual

Order No. TL1001S003V1.1
Rev.
Service Manual
Issue
6-2-6
6-2-7
19
No spinning
The washing and draining
are normal.
Check the On/off point of
the microswtich and stop
switch.
Normal
At this time please check if the
drain motor is well.
Replace the retarder clutch.
Replace the drain motor.
Replace the microswitch or stop
switch.
Too much spinning noise
If the washing machine is
set horizontally?
Yes
Yes
No On/Off point
Check if the clutch pawl is
pulled enough.
No
Set the machine horizontally.
If the hanger is wrong used?
Replace the hanger is
Replace the motor
Fasten the motor
Replace the retarder.
If the noise of the motor
is too much?
Yes
Yes
No
No
No
No
No
Yes
If the motor is fastened tightly?
If the bearing of the retarder is
well?
The hanger seat is lack of oil,
Inject oil at the hanger seat.
Yes
Yes
Yes
Yes
Yes
No
No
No
No
Fix the connecting pipe and
the wire unit.
If the connecting pipe or
the wire unit bumps
the outer tub?
Adjust the gap between the
balance ring and the outer tub.
Adjust the cabinet to acquire
balance.
Adjust the angle or the distance of
the ratchet and pawl. The distance
between the ratchet and the pawl is
above 2mm.
If the balance ring is rubbing
the outer tub cover?
If the machine body
vibrate resonantly with the
cabinet?
If the departing of the
ratchet and pawl is well?

Haier HLP24E Specifications

General

Door hinge	Up
Drum volume	42.4 L
Control type	Buttons
Display type	LED
Loading type	Top-load
Drum material	Stainless steel
Product color	White
Built-in display	Yes
Appliance placement	Freestanding
AC input voltage	120 V
AC input frequency	60 Hz
Energy consumption washing per cycle	- kWh
Drum capacity	- kg
Spin-drying class	-
Maximum spin speed	800 RPM
Noise level (spin)	- dB
Load balancing system	No
Number of washing programs	3

Weight and Dimensions

Depth	510 mm
Width	500 mm
Height	901.7 mm
Weight	19504 g