4 - System setup
149
Upgrade Firmware
μ
ATTENTION! The .fw3 is a firmware upgrade file for the display and control modules. Install firmware updates from USB
drive.
Pressing the Upgrade Firmware button allows you to upgrade the display firmware from the .fw3 file stored on the USB drive.
At the File Selection screen, scroll through the list of files on the USB drive until you find the .fw3 firmware file. Highlight the
.fw3 file and the box at the upper right-hand side of the File Selection screen shows the version of this file.
Press to continue, and the Upgrade screen informs you that the upgrade is beginning. At the Upgrade Ready screen,
press .
±
WARNING! Do not disconnect display power when the upgrade is taking place.
Importing Logged Data
.AGSETUP
Use to transfer setup information from display to display or from SMS and display.
• Allows full synchronization of the following file formats:
• Management Data (Growers, Farms, Fields, Seasons, Operators)
• Products and Product Mixes
• Boundaries
• Guidance Patterns
• Marker Sets and Markers
• Configurations
÷
NOTE! Do not use the IBK to “clone” a display. Use AGSETUP or make a new setup.
.AGDATA
• Includes all the necessary data to fully archive in SMS
• Includes recorded operation data
• Equipment Used
• Products Used
• Marks Logged
• Boundaries
• Guidance Patterns
• Flexible export options
• Able to export by Grower
To Next Page
Loading...
Need help?
General
