Harris APEX User Manual

APEX™ Exciter Incorporating FLO™ Technology
Navigating the LCD Display Screens Details of the System Setup Screens
Page: 3-50 888-2604-001 03/08/07
WARNING: Disconnect primary power prior to servicing.
3.6.7.3 FPGA Configure 3/5
FPGASetup3.bmp
Figure 3-42 FPGA Configure 3/5
FPGA Configure 3/5 consists of registers whose values are written immediately to the
FPGA when changed through the GUI.
FPGA re-initialization shall occur automatically after any of these registers are changed.
The parameters of the FPGA Configure 3/5 screen are as follows.
• Transmitter Delay: (Time in microseconds – see below for calculations)
• NTWK Geog Delay: (Time in microseconds – see below for calculations)
The value for Transmitter Delay shall be displayed in integer microseconds with a valid
range and the value for the FPGA register value calculated (rounded up to the next integer
value) as shown in the following table:
The value for Network Geographic Delay shall be displayed in integer microseconds with
a valid range and the value for the FPGA register value calculated (rounded up or down to
the next integer value) as shown in the following table:
Bandwidth
Value Range
(in u seconds)
FPGA Register
5 MHz 0 - 221 Value * 37.0
6 MHz 0 - 184 Value * 44.4
7 MHz 0 - 158 Value * 51.8
8 MHz 0 - 137 Value * 59.2
Bandwidth
Value Range
(in u seconds)
FPGA Register
5 MHz -220 - +221 Value * 37.0
6 MHz -183 - +184 Value * 44.4
7 MHz -157 - +158 Value * 51.8
8 MHz -136 - +137 Value * 59.2

Harris APEX Specifications

General

Brand	Harris
Model	APEX
Category	Transmitter
Language	English