HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING User Manual

284 Cycles: Coordinate Transformations
11.6 ROTATION (Cycle 10, DIN/ISO: G73)
11.6 ROTATION (Cycle 10, DIN/ISO:
G73)
Effect
The TNC can rotate the coordinate system about the active datum in
the working plane within a program.
The ROTATION cycle becomes effective as soon as it is defined in the
program. It is also effective in the Positioning with MDI mode of
operation. The active rotation angle is shown in the additional status
display.
Reference axis for the rotation angle:
 X/Y plane X axis
 Y/Z plane Y axis
 Z/X plane Z axis
Reset
Program the ROTATION cycle once again with a rotation angle of 0°.
Please note while programming:
Z
Z
X
X
Y
Y
X
Y
60
40
35°
X
Y
An active radius compensation is canceled by defining
Cycle 10 and must therefore be reprogrammed, if
necessary.
After defining Cycle 10, you must move both axes of the
working plane to activate rotation for all axes.

HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING Specifications

General

Brand	HEIDENHAIN
Model	ITNC 530 - CYCLE PROGRAMMING
Category	Control Panel
Language	English