HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING User Manual

HEIDENHAIN iTNC 530 45
1.2 Available Cycle Groups
1.2 Available Cycle Groups
Overview of fixed cycles
U The soft-key row shows the available groups of
cycles.
U If required, switch to machine-specific fixed cycles.
These fixed cycles can be integrated by your machine
tool builder.
Cycle group Soft key Page
Cycles for pecking, reaming, boring, and counterboring Page 72
Cycles for tapping, thread cutting and thread milling Page 106
Cycles for milling pockets, studs and slots Page 140
Cycles for producing point patterns, such as circular or linear hole patterns Page 172
SL (Subcontour List) cycles which allow the contour-parallel machining of relatively complex
contours consisting of several overlapping subcontours, cylinder surface interpolation
Page 184
Cycles for multipass milling of flat or twisted surfaces Page 254
Coordinate transformation cycles which enable datum shift, rotation, mirror image, enlarging
and reducing for various contours
Page 272
Special cycles such as dwell time, program call, oriented spindle stop and tolerance Page 302

HEIDENHAIN ITNC 530 - CYCLE PROGRAMMING Specifications

General

Brand	HEIDENHAIN
Model	ITNC 530 - CYCLE PROGRAMMING
Category	Control Panel
Language	English