eXtendo
®
Thermal Printer Family
HENGSTLER
Part No. D 684 124 Mod. No. 4 080812 LEV page 34 of 38
13. Technical Specifications
13.1. X-56 Specifications
Technology: Direct Thermal
Print Speed: 24 VDC: 13.7 ips (350 mm/sec) max.
12 VDC: 5.1 ips (130 mm/sec) max.
10-36 VDC: 5.1 ips (130 mm/sec) max.
Duty Cycle: 24 VDC: Thirty (30) 150 mm long printouts per minute max.
12 VDC: Fifteen (15) 150 mm long printouts per minute max.
10-36 VDC: For each printout up to 210 mm long and with a
print density of 25% or less, a 9 second pause after each
printout. Consult factory regarding duty cycle for print
densities over 25%.
Resolution: 203 dpi (8 dots/mm)
Minimum Print Length: 15 mm (Note; At a length of 15 mm, the paper will not be
visible at the end of the paper chute. Print at least 40 mm
in order for the paper to be visible. The 15 mm minimum
length is included to allow for applications where the
printer is ordered without the chute and where very short
printouts may be dropped into a chute or similar
conveyance.)
Printhead Life
Abrasion (based 100 km of paper
on 12.5% print density)
Electrical: 100 million dot pulses
Graphic Driver: Windows
®
2000/XP, Linux
Bar Codes:
Internally Generated: UPC-A, UPC-E, EAN-13, EAN-8, Code 39,
Interleaved 2 of 5, Code 128, Codabar, PDF 417
Externally Generated: Any, generated by Windows
®
standard GDI file by host
Paper Width: 1.93 to 2.36 inches (49-60 mm)
Printable Width: 2.20 inches (56 mm)
Paper Weight: 50 to 250 g/m² (higher in some cases)
Paper Capacity: 6 inch (150 mm) roll diameter
12 inch (300 mm) (reduced performance)
Interface Types: a) USB 1.1 industrial
Interface cable length 3 meters max.
Transmission rate: 1.5 Mbit/sec and 12 Mbit/sec
b) RS-232
Interface cable length 3 meters max.
9,600 to 115,200 baud
Operating Voltage: 24 VDC± 5%
12 VDC (11-15 VDC) (optional)
10-36 VDC (optional)
Current Draw:
In standby, approx. 150 mA
Sleep mode (optional) <50 µA
While printing
24 VDC With Hengstler paper, at 21°C ambient temperature, with a
print speed of 100 mm/sec, voltage of 24.0 VDC, and print
density (coverage) of 12.5%: 1.0 A avg.
With Hengstler paper, at 21°C ambient temperature, with a
print speed of 100 mm/sec, voltage of 24.0 VDC, and print
To Next Page
Loading...
Need help?
General
