Thermal Image Scope User Manual
vi
Safety Instruction
These instructions are intended to ensure that user can use the product correctly to avoid danger
or property loss.
Laws and Regulations
● Use of the product must be in strict compliance with the local electrical safety regulations.
Transportation
● Keep the device in original or similar packaging while transporting it.
● Keep all wrappers after unpacking them for future use. In case of any failure occurred, you need
to return the device to the factory with the original wrapper. Transportation without the
original wrapper may result in damage on the device and the company shall not take any
responsibilities.
● DO NOT drop the product or subject it to physical shock. Keep the device away from magnetic
interference.
Power Supply
● Please purchase the charger by yourself. Input voltage should meet the Limited Power Source (5
VDC, 2A) according to the IEC62368 standard. Please refer to technical specifications for
detailed information.
● Use the power adapter provided by qualified manufacturer. Refer to the product specification
for detailed power requirements.
● Make sure the plug is properly connected to the power socket.
● DO NOT connect multiple devices to one power adapter, to avoid over-heating or fire hazards
caused by overload.
Battery
● Improper use or replacement of the battery may result in explosion hazard. Replace with the
same or equivalent type only.
● The device supports 3.0 V or 3.7 V rechargeable lithium battery or 3.0 V non-rechargeable dry
battery.
● The battery size shall meet the requirements on CR17345 battery according to the IEC60086-2
standard.
● Batteries of improper size cannot be installed, and may cause abnormal shutdown.
● Confirm there is no flammable material within 2 m of the charger during charging.
● DO NOT place the battery near heating or fire source. Avoid direct sunlight.
● DO NOT place the battery in the reach of children.
Maintenance
● If the product does not work properly, please contact your dealer or the nearest service center.
We shall not assume any responsibility for problems caused by unauthorized repair or
maintenance.
To Next Page
Loading...
Need help?
General
