Thermal Image Scope User Manual
vii
● Wipe the device gently with a clean cloth and a small quantity of ethanol, if necessary.
● If the equipment is used in a manner not specified by the manufacturer, the protection
provided by the device may be impaired.
● It is recommended to reboot the device every 2 hours when using it to ensure the device
performance.
Using Environment
● Make sure the running environment meets the requirement of the device. The operating
temperature shall be -20 °C to 55 °C (-4 °F to 131 °F), and the operating humidity shall be 95% or
less.
● DO NOT expose the device to high electromagnetic radiation or dusty environments.
● DO NOT aim the lens at the sun or any other bright light.
● Place the device in a dry and well-ventilated environment.
● When any laser equipment is in use, make sure that the device lens is not exposed to the laser
beam, or it may burn out.
Emergency
● If smoke, odor, or noise arises from the device, immediately turn off the power, unplug the
power cable, and contact the service center.
Manufacture Address
Room 313, Unit B, Building 2, 399 Danfeng Road, Xixing Subdistrict, Binjiang District, Hangzhou,
Zhejiang 310052, China
Hangzhou Microimage Software Co., Ltd.
COMPLIANCE NOTICE: The thermal series products might be subject to export controls in various
countries or regions, including without limitation, the United States, European Union, United
Kingdom and/or other member countries of the Wassenaar Arrangement. Please consult your
professional legal or compliance expert or local government authorities for any necessary export
license requirements if you intend to transfer, export, re-export the thermal series products
between different countries.
To Next Page
Loading...
Need help?
General
