HD-TVI Speed Dome DS-2AE7232TI-A User Manual
UM THD DS-2AE7232T-x 020519NA 26
Figure 11, IR Settings
2. Set the IR LED sensitivity. This sets how low the ambient light must be to activate the IR LED. You can
set the SENSITIVITY to HIGH (activates with a high level of ambient light), MEDIUM (activates with a
medium level of ambient light), or LOW (activates with a low level of ambient light).
3. Set the electricity level of the IR LED. The N/M LED CURRENT and the FAR LED CURRENT refer to the
electricity level of the near/middle IR LED and far IR LED correspondingly. You can set the near/far LED
current and the far LED current to 1 to 10.
4. Set the parameters for reference zoom. The value of REFERENCE ZOOM can be adjusted from 2 to 10.
5. Set the parameters of LED control. LED control can be set to ALL ON (enable all the IR LED), FAR ON
(enable far-distance IR LED), NEAR ON (enable near/medium-distance IR LED), AUTO (enable IR LED
automatically according to the environment illumination), ICR (Infrared Cut Removable or IR Cut Filter;
adjust the IR LED working mode according to the ICR), and CLOSE (disable IR LED).
6. Set the IR LED switch delay. The SWITCH DELAY(S) refers to the delay time between switching between
the far-distance IR LED and the N/M-distance IR LED.
7. Set the Smart IR. The brightness of the IR automatically changes according to the focal length. The
greater the value, the more obvious the brightness changes.
Configuring PTZ Control Parameters
Purpose:
You can configure panning, tilting, and zooming movements, and configure PTZ control functions
including presets, patrols, patterns, etc. for the speed dome.
Configuring PTZ Parameters
1. Enter the PTZ configuration menu: MAIN MENU > DOME SETTINGS > MOTION PARAMETER.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
