HD-TVI Speed Dome DS-2AE7232TI-A User Manual
UM THD DS-2AE7232T-x 020519NA 34
5. Set the task time.
A. Move the cursor to TASK TIME and click IRIS+ to enter editing mode.
B. Click the left and right direction buttons to position the cursor to WEEK, START (H-M), and END (H-
M).
C. Click the up and down direction buttons to set the start time and end time to run the time task.
D. Click IRIS+ to confirm the settings and exit.
NOTE: The weekday can be set from Monday to Sunday or Whole Week; the H refers to Hour and the
M refers to Minute.
Figure 19, Set the Task Time
6. Delete the task. Move the cursor to TASK CLEAR, click IRIS+ to delete the time and action of the current
task, and click IRIS+ again to confirm the settings and exit.
Configuring Zone
Purpose:
A zone is a panning and tilting area defined by the left/right limits. You can configure the zones on ZONES
submenu. You can define a zone when the targeted surveillance scene is limited.
1. Move the cursor to enter the zone configuration submenu: MAIN MENU > DOME SETTINGS > ZONES.
Figure 20, Zone Configuration
To Next Page
Loading...
Need help?
General
Weight and Dimensions
