Network Camera User Manual
54
6.3.3 System Service
Purpose:
System service settings refer to the hardware service the camera supports. Supported
functions vary according to the different cameras. For the cameras support IR Light,
ABF (Auto Back Focus), Auto Defog, or Status LED, you can select to enable or disable
the corresponding service according to the actual demands.
Note: Only certain device models support this function.
ABF: When ABF function is enabled, you can click on PTZ control panel to realize
auxiliary focus.
Third Stream: For some models, third stream is not enabled by default. Check Enable
Third Stream to enable the function.
eMMC Protection: If you enable eMMC protection, the lifespan of the eMMC is
displayed.
Enable Motion Detection: Check Enable Motion Detection to enable the function.
6.3.4 Security Audit Log
Purpose:
The security audit logs refer to the security operation logs. You can search and analyze
the security log files of the camera so that to find out the illegal intrusion and
troubleshooting the security events. Security audit logs can be saved on device flash.
The log will be saved every half hour after device booting.
Due to limited saving space of the flash, you can also save the logs on a log server.
Configure the server settings at Advanced Settings.
Note: Only certain camera models support the function.
Searching Logs
Steps:
1. Enter log searching interface: Configuration > System > Maintenance > Security
Audit Log.
To Next Page
Loading...
Need help?
General
