Network Camera User Manual
87
1. Check Enable ONVIF to enable the function.
2. Add ONVIF users. Up to 32 users are allowed.
Set the user name and password, and confirm the password. You can set the
user as media user, operator, and administrator.
Note: ONVIF user account is different from the camera user account. You have
set ONVIF user account independently.
3. Save the settings.
Note: User settings of ONVIF are cleared when you restore the camera.
Bandwidth Adaptation
When you enable the function, live view fluency is taken as the priority of camera
performance. The camera adjusts video-related parameters automatically, and the
pre-set video-related configuration is invalid. A reboot is required for the function to
take effect.
Note: Bandwidth adaptation is only available for certain camera models.
7.2.11 Network Service
You can control the ON/OFF status of certain protocol that the camera supports.
Note:
• Keep unused function OFF for security concern.
• Only certain camera models support the function.
WebSocket and WebSockets
WebSocket or WebSockets protocol should be enabled if you use Google Chrome 45
and its above version or Mozilla Firefox 52 and its above version to visit your camera.
Otherwise, live view, image capture, and digital zoom function cannot be used.
If the camera uses HTTP, enable WebSocket.
If the camera uses HTTPS, enable WebSockets.
SDK Service and Enhanced SDK Service
If you want to add the device to the client software, you should enable SDK Service
To Next Page
Loading...
Need help?
General
