Network Camera User Manual
90
The camera can send alarm information to the destination IP or host name via HTTP,
HTTPS, or ISUP protocol. If the network is disconnected, the data can be uploaded to
the destination IP or host name after the network connection is normal.
Before you start:
The destination IP or host name should support the HTTP, HTTPS, or ISUP protocol to
receive the alarm information.
Steps:
1. Enter the HTTP Listening interface, Configuration > Network > Advanced Settings >
Security Control Panel Configuration.
Figure 7-18 HTTP Listening
2. Enter the desired destination IP or host name, URL and port.
3. You can click Test to test whether the entered IP address or host name are valid.
4. Or you can click Default to reset the destination IP or host name.
Note: Only certain camera models support the function.
To Next Page
Loading...
Need help?
General
