Network Speed Dome User Manual
for motion detection. Refer to Step 2 in Section 5.2.1 Configuring Motion
Detection.
5. Click tab to select the linkage method taken for the video loss
alarm, including Notify surveillance center, send email, trigger channel, smart
tracking and trigger alarm output are selectable. Please Step 3 in Section 5.2.1
Configuring Motion Detection.
6. You can also choose the PTZ linking for the alarm input. Check the relative
checkbox and select the No. to enable Preset Calling, Patrol Calling or Pattern
Calling.
7. You can copy your settings to other alarm inputs.
8. Click to save the settings.
Figure 5-20 Linkage Method
5.2.5 Configuring Alarm Output
Steps:
1. Enter the Alarm Output Settings interface:
Configuration> Event > Basic Event > Alarm Output
2. Select one alarm output channel in the Alarm Output drop-down list.
3. Set a name in for the alarm
output (optional).
4. The Delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min, 10min or
Manual. The delay time refers to the time duration that the alarm output
remains in effect after alarm occurs.
5. Click tab to enter the arming schedule setting interface. The
To Next Page
Loading...
Need help?
General
