DS-2TD2xxx-xx/xx Thermal and Optical Bi-Spectrum Network Bullet Camera Quick Start Guide
QSG DS-2TD2xxx-xx/xx 071720NA 4
Symbol Convention
The symbols that may be found in this document are defined as follows.
Provides additional information to emphasize or supplement imp
main text.
WARNING
Indicates a potentially hazardous situation, which if not avoided, could result in
equipment damage, data loss, performance degradation, or unexpected results.
DANGER
Indicates a hazard with a high level of ris
k, which if not avoided, will result in death or
serious injury.
Safety Instruction
These instructions are intended to ensure that user can use the product correctly to avoid danger or
property loss.
Laws and Regulations
•
The lightning protection and grounding design of outdoor installation and wiring should be in
compliance with the lightning protection requirements of the buildings and local laws and regulations.
•
Use of the product must be in strict compliance with the local electrical safety regulations.
Storage
•
Store the device in a dry, well-ventilated, corrosive-gas-free, no direct sunlight, and no heating
source environment. Neglect may cause fire hazard.
•
To avoid heat accumulation, good ventilation is required for a proper operating environment.
•
DO NOT touch the heat dissipation component to avoid burns.
Transportation
•
Keep the device in original or similar packaging while transporting it.
•
Keep all wrappers after unpacking them for future use. In case any failure occurs, you need to return
the device to the factory with the original wrapper. Transportation without the original wrapper may
result in damage to the device, and the company shall not take any responsibilities.
•
DO NOT drop the product or subject it to physical shock. Keep the device away from magnetic
interference.
Installation
•
When the device is mounted on a wall or ceiling, the device shall be firmly fixed.
•
Avoid equipment installation on vibratory surface or places subject to shock (neglect may cause
equipment damage).