DS-2TD2xxx-xxxx/xx Thermal and Optical Bi-Spectrum Network Camera User Manual
UM DS-2TD2xx-xxxx/xx Thermal 072020NA 12
4. Set device activation password.
STRONG PASSWORD RECOMMENDED − We highly recommend that you create a strong password
of your own choosing (using a minimum of eight characters, including at least three of the
following categories: upper case letters, lower case letters, numbers, and special
characters) in order to increase the security of your product. We also recommend that you
reset your password regularly. Especially in high security systems, resetting the password
monthly or weekly can better protect your product.
Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
5. Click OK.
6. Input the activation password to log in to the device.
7. (Optional): Go to Configuration → Network → Basic → TCP/IP to change the IP address of the device to the
same segment of your network.
2.3 Login
Log in to the device via a Web browser.
2.3.1 Install Plug-in
You can access the device by installing a plug-in.
1. Input IP address of the device in a Web browser, and the login window will pop up.
2. Install the plug-in according to the prompt.
3. Open the Web browser again, and input the device IP address.
4. Input user name and password, and click Login.
• Help: Get online help document of the device.
• Logout : You can exit safely.
2.3.2 Illegal Login Lock
It helps to improve security when accessing the device via the Internet.
The admin user can set the number of login attempts with a wrong password. When the login attempts
with a wrong password reaches the set number, the device will lock.
Go to Configuration → System → Security → Security Service, enable Enable Illegal Login Lock, and set the
number of illegal login attempts.
To Next Page
Loading...
Need help?
General
