DS-2TD2xxx-xxxx/xx Thermal and Optical Bi-Spectrum Network Camera User Manual
UM DS-2TD2xx-xxxx/xx Thermal 072020NA 69
4. (Optional): Click Export to save the log files to your computer.
12.13.3 Set IP Address Filter
IP address filter is a tool for access control. You can enable the IP address filter to allow or forbid visits
from certain IP addresses.
IP address refers to IPv4.
1. Go to Configuration → System → Security → IP Address Filter.
2. Check Enable IP Address Filter.
3. Select the type of IP address filter.
• Forbidden: IP addresses in the list cannot access the device.
• Allowed: Only IP addresses in the list can access the device.
4. Edit the IP address filter list.
• Add: Add a new IP address to the list.
• Modify: Modify the selected IP address in the list.
• Delete: Delete the selected IP address in the list.
5. Click Save.
12.13.4 Set SSH
SSH is a protocol to ensure remote login security. This setting is reserved for professional maintenance
personnel only.
1. Go to Configuration → System → Security → Security Service.
2. Check Enable SSH.
3. Click Save.
12.13.5 Set HTTPS
HTTPS is a network protocol that enables encrypted transmission and identity authentication, which
improves remote access security.
1. Go to Configuration → Network → Advanced Settings → HTTPS.
2. Check Enable.
3. Click Delete to recreate and install certificate.
• Create and install self-signed certificate: Refer to Create and Install Self-signed Certificate
To Next Page
Loading...
Need help?
General
