DS-2TD2xxx-xxxx/xx Thermal and Optical Bi-Spectrum Network Camera User Manual
UM DS-2TD2xx-xxxx/xx Thermal 072020NA 34
external alarm device.
• Alarm Name: Customize a name for the alarm output.
• Delay: Select Manual.
2. Click Manual Alarm to enable manual alarm output.
3. (Optional): Click Clear Alarm to disable manual alarm output.
Automatic Alarm
Set the automatic alarm parameters, then the device will trigger an alarm output automatically in the set
arming schedule.
1. Set automatic alarm parameters.
• Alarm Output No.: Select the alarm output no. according to the alarm interface connected to the
external alarm device.
• Alarm Name: Customize a name for the alarm output.
• Delay: Refers to the time duration that the alarm output remains after an alarm occurs.
2. Set the alarming schedule. For information about the settings, see Set Arming Schedule.
3. Click Copy to… to copy the parameters to other alarm output channels.
4. Click Save.
7.2.2 FTP/NAS/Memory Card Uploading
If you have enabled and configured the FTP/NAS/memory card uploading, the device sends the alarm
information to the FTP server, network attached storage, and memory card when an alarm is triggered.
• See Set FTP to set the FTP server.
• See Set NAS for NAS configuration.
• See Set Memory Card for memory card storage configuration.
7.2.3 Send Email
Check Send Email, and the device sends an e-mail to the designated addresses with alarm information
when an alarm event is detected.
For e-mail settings, see Set Email.
Set Email
When e-mail is configured and Send Email is enabled as a linkage method, the device sends an e-mail
notification to all designated receivers if an alarm event is detected.
Before You Start
Set the DNS server before using the Email function. Go to Configuration → Network → Basic Settings →
To Next Page
Loading...
Need help?
General
