Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
38
Figure 7-3 Set Video Tampering Area
6. Refer to Set Arming Schedule for setting scheduled time. Refer to Linkage Method Settings for
setting linkage method.
7. Click Save.
7.3 Set Alarm Input
Alarm signal from the external device triggers the corresponding actions of the current device.
Before You Start
Note
This function is only supported by certain models.
Make sure the external alarm device is connected. See Quick Start Guide for cable connection.
Steps
1. Go to Configuration → Event → Basic Event → Alarm Input.
2. Check Enable Alarm Input Handling.
To Next Page
Loading...
Need help?
General
