Thermal & Optical Bi-spectrum PTZ Network Camera User Manual
53
9.9 Set Privacy Mask
Privacy masks cover certain areas on the live image to protect personal privacy from being live
viewed and recorded.
Steps
1. Go to Configuration → PTZ → Privacy Mask.
2. Select a channel.
3. Adjust the live image to the target scene via PTZ control buttons.
4. Draw the area.
Click Draw Area, and click on the live view
image to determine the boundary of the
mask.
5. Click Add.
It is listed in Privacy Mask List.
6. Edit Name, Type, and Active Zoom Ratio on your demand.
Active Zoom Ratio
When the actual zoom ratio is less than the set active zoom ratio, the set area can not be
covered. When the actual zoom ratio is greater than the set active zoom ratio, the privacy
mask is valid. The maximum value of active zoom ratio depends on the camera module.
Note
Active zoom ratio is only supported for the PTZ channel.
7. Repeat the steps above to set other privacy masks.
8. Check Enable Privacy Masks.
9.10 Set Scheduled Tasks
You can set the device to perform a certain task during a certain period.
Steps
1. Go to Configuration → PTZ → Scheduled Tasks.
2. Check Enable Scheduled Task.
3. Select the a task type from the drop-down list and draw a time bar on the schedule table.
4. Click the set time bar and set the action ID and smart event or VCA type.
To Next Page
Loading...
Need help?
General
