HIKVISION DS-2XC6745G0-IZHS User Manual

Before You Start
●
Go to VCA and select the applicaon. Select Smart Event and click Next to enable the funcon.
●
For the device supporng HEOP, go to VCA to import and enable Smart Event.
Steps
1.
Go to VCA → Set
Applicaon → Smart Event → Region Exing Detecon .
2.
Check Enable.
3.
Click Add to add a rule and set a
detecon area.
1) Draw a detecon area. Click , click on the live view to specify the vertexes and draw the
boundaries of the
detecon area, and right click to complete drawing.
2) Set the minimum size and the maximum size for the target to improve detecon accuracy.
Only targets whose size are between the maximum size and the minimum size trigger the
detecon. Click and , then drag the mouse in the live view to draw the minimum and
maximum target size.
3)
Oponal: Click to delete all the seng areas.
4.
Set parameters.
Detecon Target
This funcon allows alarm triggering by specied selected target types. If the detecon target
is not selected, all the detected targets will be reported.
Note
This funcon is only available for certain device models under certain sengs. Please refer to
the actual sengs.
Sensivity
It stands for the percentage of the body part of an acceptable target that goes across the
predened region. Sensivity = 100 - S1/ST × 100. S1 stands for the target body part that goes
across the predened region. ST stands for the complete target body. The higher the value of
sensivity is, the more easily the alarm can be triggered.
Target Validity
If you set a higher validity, the required target features should be more obvious, and the
alarm accuracy would be higher. The target with less obvious features would be missing.
Network Camera User Manual
81

HIKVISION DS-2XC6745G0-IZHS Specifications

General

Brand	HIKVISION
Model	DS-2XC6745G0-IZHS
Category	Security Camera
Language	English