HIKVISION iDS-TCD403-BI User Manual

10.8 Set DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
funcon.
Steps
1.
Go to Conguraon → System → System Sengs → DST .
2.
Check Enable DST.
3.
Set Start Time, End Time, and DST Bias.
4.
Click Save.
10.9 Debug
Note
The debug conguraons below are only provided to debug the device by the professionals.
10.9.1 Debug Device
You can enable the funcons to debug the device.
Steps
1.
Go to Conguraon → Capture → Advanced → System Service .
2.
Check the debug informaon according to your needs.
Note
The supported parameters vary with dierent models. The actual device prevails.
Enable Algorithm POS Informaon Debug
The algorithm POS informaon will be overlaid on the playback image when you play back
the video with the dedicated tool.
Enable Posioning Frame Debug
The posioning frames of vehicle bodies and license plates will be overlaid on the captured
pictures.
Enable Closed
Posioning Frame
The boom lines of the posioning frames on the captured pictures will be displayed. The
frames will be closed.
Enable LPR Area Frame
The LPR area frames on the captured pictures will be displayed.
Network Trac Camera Operaon Manual
56

HIKVISION iDS-TCD403-BI Specifications

General

Brand	HIKVISION
Model	iDS-TCD403-BI
Category	Security Camera
Language	English