HIKVISION iDS-TCD403-BI User Manual

Note
The funcon is only valid in the trigger modes of checkpoint single I/O and RS-485 radar, and
manual capture. In these modes, the license plate may not be included in the LPR area, and
the LPR rate is low. To solve the problem, you can enable the funcon to add a green frame
on the captured picture to check whether the license plate is included in the LPR area.
LPR Area Frame Y-Direcon Deviaon
If the license plate is not included in the LPR area frame, adjust the LPR area frame posion in
the Y-direcon by pixel. Enter the deviaon pixel in the text eld. The value = image height ×
(deviaon distance/100). Set the value according to the actual needs. Range: -100% to 100%.
The LPR area frame moves up if the value is
negave, and it moves down if the value is
posive.
Enable License Plate Frame
The license plate frames will be overlaid on the captured pictures.
Enable Mul-Way Upload
Data will be uploaded in mulple set ways simultaneously.
Enable Lane Line Debug
Check it to overlay lane lines on a captured picture.
3.
Click Save.
10.9.2 Vehicle Capture and
Recognion Service
Set the vehicle capture and recognion service to debug the device.
Steps
Note
The funcon varies with dierent models. The actual device prevails.
1.
Go to Conguraon → Capture → Advanced → Vehicle Capture and Recognion Service .
2.
Check the service(s) according to your needs.
Note
The supported services vary with dierent models. The actual device prevails.
Filter Checkpoint Capture of Same Vehicle
It is used to debug the device with the same vehicle. When the same vehicle is triggered
many
mes during a short period in the scene, the checkpoint pictures of the vehicle will not
be captured.
Network Trac Camera Operaon Manual
57

HIKVISION iDS-TCD403-BI Specifications

General

Brand	HIKVISION
Model	iDS-TCD403-BI
Category	Security Camera
Language	English