HIKVISION iDS-TCH44P-B User Manual

Select it when dierent LANs are connected. Set the IP addresses of dierent network
segments.
Note
The dual-NIC mode varies with dierent models. The actual device prevails.
3.
Set the parameters below.
NIC Type
Select a NIC (Network Interface Card) type according to your network condion.
IP Address
Two modes are available.
DHCP
The device
automacally gets the IP parameters from the network if you check DHCP. The
device IP address is changed aer enabling the funcon. You can use SADP to get the device
IP address.
Note
The network that the device is connected to should support DHCP (Dynamic Host
Conguraon Protocol).
Manual
You can set the device IP parameters manually. Enter IP Address, Subnet Mask, and
Gateway.
IPv6
Three IPv6 modes are available.
Route
Adversement
The IPv6 address is generated by combining the route adversement and the device Mac
address.
Note
Route adversement mode requires the support from the router that the device is
connected to.
DHCP
The IPv6 address is assigned by the server, router, or gateway.
Manual
Enter IPv6 Address, IPv6 Subnet Mask, and IPv6 Gateway. Consult the network
administrator for required
informaon.
MTU
Network Trac Camera (Mul-lens LPR Camera) User Manual
37

HIKVISION iDS-TCH44P-B Specifications

General

Brand	HIKVISION
Model	iDS-TCH44P-B
Category	Security Camera
Language	English