2.6 Advanced Settings and Functions
This section describes how to initialize the instrument’s settings.
All measurement data (up to 2,000 values) will be deleted.
To disable APS temporarily
Turn on the instrument by pressing the POWER key
while holding down the HOLD key to disable APS until
the next time the instrument’s power is cycled. The next
time the power is cycled, APS will be enabled (as long
as the APS setting is enabled in sub-function mode).
Reverting the instrument to factory settings
(system reset)
1.
Enter sub-function mode.
Press the
POWER
key while holding down the
Fn
key.
2.
Using the
▼
and
▲
keys, select the System Reset screen
and press the
OK
key. The
[OK?]
mark will flash.
3.
Press the
OK
key again. The instrument will revert to the fac-
tory settings.
• If the System Reset screen is displayed by mistake,
cycle the instrument's power without pressing the OK
key. Instrument operation will be restored without a
system reset having been performed.
•
For more information about how to clear previously saved
measurement data, see "Clearing stored data (p.40)".
www.GlobalTestSupply.com
Find Quality Products Online at: sales@GlobalTestSupply.com
To Next Page
Loading...
Need help?
General
