20
Installation MACH102
Release
06
09/2014
2 Assembly and start-up
The devices have been developed for practical application in a harsh indus-
trial environment.
On delivery, the device is ready for operation.
The following procedure has been proven to be successful for the assembly
of the device:
Unpacking and checking
Installing the media modules
Installing the SFP modules
Signal contact
Installing the device and grounding
Supply voltage
Startup
Connecting the data lines
2.1 Installing the device
2.1.1 Unpacking and checking the content of the package
Check whether the package includes all items named in section “Scope
of delivery” on page 44.
Check the individual parts for transport damage.
2.1.2 Installing media modules
On delivery, the device is ready for operation.
The modules can be used in
MACH 102-8TP basic device
MACH 102-8TP-R basic device
See the ESD guidelines (see on page 6 “ESD Guidelines”) and the safety
instructions (see on page 4 “Safety instructions”).
The media modules are hot-plug-compatible, which means that you have the
option of replacing the modules with a module of the same kind during oper-
ation.
Note: If you are replacing media, e.g. removing a TX media module and plug-
ging in an FX media module in its place, the MACH102 performs a warm
start.
To Next Page
Loading...
Need help?
General
