6
Installation MACH102
Release
06
09/2014
General safety instructions
This device is operated by electricity. You must follow precisely the
prescribed safety requirements for the voltage connections in this docu-
ment.
Non-observance of these safety instructions can cause material damage
and/or injuries.
Only appropriately qualified personnel should work on this device or in
its vicinity. The personnel must be thoroughly familiar with all the warn-
ings and maintenance procedures outlined in this operating manual.
The proper and safe operation of this device depends on proper
handling during transportation, proper storage and assembly, and
conscientious operation and maintenance procedures.
Never start operation with damaged components.
Only use the devices in accordance with this manual. In particular,
observe all warnings and safety-related information.
Any work that may be required on the electrical installation may only
be carried out by personnel trained for this purpose.
Please note that products recommended as accessories may have
characteristics that do not fully correspond to those of the corre-
sponding product. This may limit their possible usage in the overall
system.
Note: LED or LASER components in compliance with IEC 60825-1
(2007):
CLASS 1 LASER PRODUCT
CLASS 1 LED PRODUCT
National and international safety regulations
Verify that the electrical installation meets local or nationally applicable
safety regulations.
ESD Guidelines
The media modules are equipped with electrostatically sensitive compo-
nents. These can be destroyed, or their life cycles reduced, by the effects
of an electrical field or by a charge equalization if the card is touched.
For this reason, the cards are packaged in a conductive ESD protective
bag on delivery. The packaging can be reused.
To Next Page
Loading...
Need help?
General
