Installation MACH102
Release
06
09/2014
35
Port state
These LEDs provide port-related information.
On the M1-8TP-RJ45 PoE media module, the left LED informs you about
data and link state, as shown in table 5. The right LED informs you about
PoE voltage supply on a port, as shown in table 6:
2.3 Basic set-up
The IP parameters must be entered when the device is installed for the first
time. The device provides 6 options for configuring IP addresses:
Entry via V.24 connection
Entry using the HiDiscovery protocol via the application HiDiscovery or
Industrial HiVision
Configuration via BOOTP
Configuration via DHCP
Configuration via DHCP Option 82
Auto Configuration Adapter
Further information on the basic settings of the device can be found in the
“Basic Configuration” user manual on the CD/DVD.
Default settings
IP address: The device looks for the IP address using DHCP
Management password:
user, password: public (read only)
admin, password: private (read and write)
V.24 data rate: 9,600 Baud
Ring redundancy: off
LS - data, link status (one green/yellow LED or one green and one yellow LED)
Not glowing No valid connection.
Glowing green Valid connection.
Flashing green (1 time a period) Port is switched to stand-by.
Flashing green (3 times a
period)
Port is switched off.
Flashing yellow Data reception.
Table 5: Data, link status
PoE voltage supply
Not glowing No PoE voltage on the port.
Glowing yellow The port is supplied with PoE voltage.
Table 6: Activity of the right LED on the M1-8TP-RJ45 PoE media module
To Next Page
Loading...
Need help?
General
