58
Enabling system standby
The system standby feature causes other components to power o when you power o your TV. Depending on the CEC
System Standby implementaon, it also might enable connected components to power o your TV when you power o
the component.
System standby is disabled by default. To enable system standby, in the screen menu, navigate to -
and highlight . Press OK to enable or disable the feature.
Restarting the TV
You can restart the TV when necessary. Restarng has the same eect as unplugging the TV power and then plugging it
in again.
To restart the TV, navigate to , and then select . Highlight , and then
press OK to conrm restart.
While the TV restarts, the screen goes dark for a few seconds, and then displays the startup screen for a few more sec-
onds. When the restart operaon completes, the TV displays the acvity you selected in “Power on sengs” on page
47.
Resetting the TV
You can choose to reset only the TV picture and audio sengs to their original values, or perform a full factory reset to
return the TV to the state it was in when you rst unpacked it and turned it on.
Reset audio/video settings
To reset only the TV picture and audio sengs to their original values, navigate to
, and then highlight . Read the informaon on the screen to make
sure you understand what the reset operaon does.
To proceed with the reset operaon, press three mes in a row.
Factory reset everything
A full factory reset returns the TV’s sengs to their original state and removes all personally idenable informaon
from the TV. When nished, you must repeat Guided Setup, reconnecng to the Internet, re-linking your Roku account,
and reloading any streaming channels. You also must repeat Antenna TV setup and input conguraon.
Factory reset is the recommended choice if you want to transfer the TV to another owner, and it is the only choice if you
want to switch from store mode to home mode (if you inadvertently selected store mode during Guided Setup).
To perform a factory reset, navigate to , and then highlight
. Read the informaon on the screen to make sure you understand what this reset operaon
does.
To proceed with the full factory reset, use the on-screen number pad to enter the code displayed on the screen, and then
select OK to proceed.
When the factory reset operaon completes, the TV restarts and displays the rst Guided Setup screen.
To Next Page
Loading...
Need help?
General
