11
Remote Control
Using the remote control
When using the remote control, aim it at the
remote control sensor at the front of the unit.
Make sure there are no large obstacles between
the remote control and the main unit.
Do not drop the remote control unit; do not
subject it to physical shocks.
Bright sunlight or lightning may cause erratic
operation.
Use of the unit near fluorescent lighting may
cause interference when using the remote
control. If the unit is displaying erratic behaviour,
move it away from any fluorescent lighting.
Keep the remote control dry. Wetting it may
cause malfunction.
Replace the batteries when remote control
operation deteriorates.
Battery precautions
Always follow the precautions below when using
batteries:
CAUTION: Danger of explosion! Ensure to insert
batteries according to the polarity markings.
Clean the battery contacts and those of the
device prior to installation.
Replace all batteries at the same time with fresh
batteries of the same size and type.
Do not mix old and new batteries, different types
of battery (alkaline, carbon-zinc or recharge-
able), or rechargeable batteries of different ca-
pacities. Mixing different types of battery could
cause leakage or rupture.
Remove the batteries when the unit is not in
use for a long time to avoid leakage. Batteries
can leak chemicals that can damage electronic
parts.
Dispose of batteries promptly and properly, ob-
serving any local hazardous waste regulations.
Do not burn or bury them.
Note that there are chargeable and noncharge-
able batteries. Do not attempt to charge non-
chargeable batteries.
Keep batteries away from children. If you sus-
pect a battery may have been swallowed, seek
immediate medical assistance.
Inserting Batteries
Place two AA size batteries in the remote control’s battery compartment, making sure to match the polar-
ity markings inside the compartment.
Open.
1
Make sure the
polarity is correct.
2
Close.
3
To Next Page
Loading...
Need help?
General
